ANALYSIS OF THE EFFECT AMOUNT OF PLATE, DIAMETER PORT, AND WIDTH OF COMPRESSION ON INTERCOOLER PERFORMANCE IN PT INDONESIA POWER

Authors

  • Elli Prastyo Akamigas Balongan Indramayu, Indonesia

DOI:

https://doi.org/10.33603/jgst.v4i2.3450

Abstract

This analysis to determine the performance of the intercooler based on actual data, and the intercooler's performance against design specifications changes using the NTU method. Variable design specifications in the study are the number of plates, compressed area, and port diameter values from intercooler specifications provided by the company. The results of the inter-device performance analysis of compatibility with the specifications required by the company amounted to 99.40%. The results of the first trial of the tool specifications point the compatibility value to increase to 99.98% by increasing the number of plates from 79 to 150 plates, reducing the compressed area value from 0.47 to 0.2 m and increasing the port diameter value from 0.2 to 0,5 m. The results of the trial 2 tool specification showed a decrease to 86.51% due to changes in variable variables, by the number of plates to 25, raising the compressed plate width to 0.5 meters and increasing the port diameter to 0.6 m. The highest overall heat transfer value on May 23-24 is 346.225,37  based on actual data calculation of Intercooler effectiveness. The lowest overall heat transfer value is 346.213,29  based on data calculation it occurred on 22 May 2019.

Author Biography

Elli Prastyo, Akamigas Balongan Indramayu

Department Chemical Engineering, Akamigas Balongan, Indramayu

References

Holman, JP, 1986, Heat Transfers: sixth edition. McGraw Hill: New York.

Shah, Ramesh K, 2003, Fundamentals Of Heat Exchanger.United States: John Wiley & Sons, Inc.

Suswanto., Et al, 2015, Heat Exchanger Heat Transfer In Double Pipe Elbow Shaped With Four Fins, Vol.10, No. 01. Tegal: University Pancasakti.

Suderajat, Jajat, 2017, Performance Analysis Tools Shell & Tube Heat Exchanger System On Booster.Jurnal Cog Mechanical Engineering, Vol 06 No 3.Jakarta: University Mercubuana.

Walikrom, Rido, 2018, Study the performance of Plate Heat Exchanger Cooling System On PLTGU, Journal of Mechanical Engineering, Vol 01 No 01. Palembang: University Tridinanti.

Downloads

Published

2020-05-06

Issue

Vol. 4 No. 2 (2020): Journal of Green Science and Technology, Vol.4 No.2 (2020)

Section

Artikel

Citation Check

License

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike 4.0 International License that allows others to share and adapt the work with an acknowledgement of the works authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journals published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Upon receiving the proofs, the Author/Editor agrees to promptly check the proofs carefully, correct any errors, and authorize the publication of the corrected proofs.